ESAB MultiPower 460 Pulse Bedienerhandbuch PDF herunterladen (Seite 23)

b. Spot Weld Time - This knob sets the spot weld time from 0 to 10 seconds and is controlled by a current detect

switch. The timer does not start until current is detected to insure consistent weld results.

c. SpotWeldSwitchPosition-WiththetoggleswitchintheSPOT(left)positiontheSPOTtimeristurned“ON”

and the spot weld time is controlled by the SPOT WELD TIMER knob.

d. Continuous Position - With the toggle switch in the CONTINUOUS (center) position the welding continues as

long as the MIG gun trigger is depressed.

e. Trigger Lock Position - With the toggle switch in the TRIGGER LOCK (right) position, the welding process begins

when the gun trigger is depressed. Once the welding has started, the gun trigger may be released without

the arc going out. To stop the welding operation, the gun trigger must be depressed a second time or by

pulling the gun away and breaking the arc. This allows a continuous weld without having to continuously

depress the gun trigger

SECTION 1 DESCRIPTION

NOTE

Weld schedule selection using the MIG gun trigger is disabled when the 4-in-1 Option panel is installed

and the the TRIGGER LATCH function is being used.

2. Digital Dual Schedule MMI Panel (PN 0558001912)

This easy to install MMI panel provides digital meters to preset wire feed speed and display both wire feed speed

and average arc voltage while welding. Both wire feed speed (IPM) and arc voltage are displayed for 10 seconds

after the weld is completed for easy viewing and recording of weld parameters. Two welding schedules can be

preset and switched during welding by using the MIG gun trigger.

3. Pulse Dual Schedule MMI Kit (PN 0558002496)

This kit includes the Pulse Dual Schedule Panel (PN-0558003005) and the Pulse Selection Module (PN-0558003007)

and provides pulse MIG welding capability using the ESAB 350MPi, MTS-3500i, MultiPower 460 or SVI-450i power

sources.

4. 4-in-1 Pre/Post Flow, Spot Weld and Trigger Lock

(PN 0558001914)

This control module provides additional weld functions to the DuraDrive wire feeder.

a. Preow/Postow - The PREFLOW control sets the time of the preow shielding gas before the wire starts feed-

ing(0-2.5sec.).ThePOSTFLOWcontrolsetsthetimetheshieldinggasremains“ON”afterthearcisturned

“OFF”(0-2.5sec.).

1 2 ... 18 19 20 21 22 23 24 25 26 27 28 ... 51 52

Keine Kommentare

ESAB MultiPower 460 Pulse Bedienerhandbuch Seite 23