ESAB MultiPower 460 Pulse Bedienerhandbuch PDF herunterladen (Seite 29)

SECTION 4

OPERATION

F. MIG & FLUX CORE WELDING PRESET PROCEDURE

When the PROCESS switch is placed in the MIG position, the MultiPower 460

Pulse is set for CV (constant voltage) welding. The power source will output open

circuit voltage (OCV) when the Mig Gun trigger is depressed. The following

procedure assumes that the wire and gas have been installed.

Step 1. Connect wire feeder to MultiPower 460 Pulse and set PANEL/RE-

MOTE switch to REMOTE position.

Step 2. Set the STANDARD/PULSE switch to the STANDARD position.

Step 3. Place the WELD PROCESS switch in the MIG (center) position.

Step 4. Press and release the PRESET button then turn the wire speed

control on the wire feeder to the desired speed shown on the top

digital display window of the MultiPower 460 Pulse.

Step 5. Turn the VOLTAGE knob on the wire feeder to the desired arc

voltage in the bottom digital display window of the MultiPower 460

Pulse.

Step 6. Set the shielding gas flow rate to 35 cfh by activating the gas purge

switch on the wire feeder or pulling the gun trigger and turning the

adjustment knob on the Flowmeter.

Step 7. Connect the work cable to the part to be welded and pull the gun

trigger to start welding. Trim the wire speed and volts as needed for

the desired arc characteristics and weld quality.

Figure 4-5 Standard Mig Setup Procedure

NOTE

"OFF THE ARC" Wire Feeders can use

either MIG (CV) or STICK (CC) Process

Selection. Place the contactor toggle switch

on the accesssory panel (see Figure 3-5) to

the "ON" position.

1 2 ... 24 25 26 27 28 29 30 31 32 33 34 ... 51 52

Keine Kommentare

ESAB MultiPower 460 Pulse Bedienerhandbuch Seite 29