ESAB MultiPower 460 Pulse Bedienerhandbuch PDF herunterladen (Seite 31)

SECTION 4

OPERATION

Figure 4-6 Synergic Pulse MIG Setup

The TRIM Knob on the front panel (Voltage knob) allows the operator to fine tune

the pulse arc length and optimize the welding characteristics. When the

PROCESS switch is placed in the MIG position and the STANDARD/PULSE

switch is place in the PULSE position, the MultiPower 460 Pulse is set for pulse

Mig welding. The MultiPower 460 Pulse provides an arc length TRIM adjustment

from either the wire feeder or power source.

The operator can change to STANDARD MIG (CV) by simply setting the

STANDARD/PULSE switch to the STANDARD position and adjusting the arc

length using the voltage control and the wire speed control.

The following procedure assumes the wire feed and voltage adjustments will be

made from the wire feeder front panel and wire and gas have been installed. See

Table 4-1 for the recommended shielding gases for each wire alloy type. Set the

flowrate at 35 to 40 cfh for argon mixtures.

H. PULSE MIG SETUP

Step 1. Place the WELD PROCESS switch in the MIG (center) position

Step 2. Set the STANDARD/PULSE switch to the PULSE position.

Step 3. Set the PANEL/REMOTE switch to the REMOTE position.

Step 4 Set the PULSE SELECTION switches to the WIRE TYPE and WIRE

DIAMETER installed on the wire feeder.

Step 5. Press and release the PRESET button. Turn the wire speed knob

on the wire feeder to the desired speed in the top digital display

window of the MultiPower 460 Pulse.

1 2 ... 26 27 28 29 30 31 32 33 34 35 36 ... 51 52

Keine Kommentare

ESAB MultiPower 460 Pulse Bedienerhandbuch Seite 31