ESAB MultiPower 460 Pulse Betriebsanleitung PDF herunterladen (Seite 16)

switch characteristics. The TRIM adjustment is calibrated such that the

preprogrammed synergic pulse data is approximately at 12 o'clock of the

TRIM knob position. The operator should preset the voltage control on the

wire feeder to the 12 o'clock position and adjust for best arc characteristics.

The operator can change to STANDARD MIG (CV) by simply moving the MIG

STANDARD/PULSE switch to the STANDARD position.

The following procedure assumes the wire feed and voltage adjustments will

be made from the wire feeder front panel and wire and gas have been installed.

See Table 4-2 for the recommended shielding gases for each wire alloy type.

Set the flowrate at 30 to 40 cfh for argon mixtures.

Figure 4-2 Synergic Pulse MIG Setup

SECTION 3 OPERATION

F. PULSE MIG SETUP

Step 1. Place the WELD PROCESS switch in the MIG (center) position

Step 2. Set the MIG STANDARD/PULSE switch to the MIG PULSE position.

Step 3. Set the PANEL/REMOTE switch to the REMOTE position.

Step 4 Set the PULSE SELECTION switches to the WIRE TYPE and WIRE

DIAMETER installed on the wire feeder.

Step 5. Press and release the PRESET button. Turn the wire speed knob

on the wire feeder to the desired speed in the top digital display

window of the MultiPower 460 Pulse.

Step 6. Turn the voltage knob of the wire feeder to the desired arc volt-

age in the bottom digital display window of the MultiPower 460

Pulse.

Step 7. Set the shielding gas flow rate to 35 cfh by activating the gas purge

switch on the wire feeder or pulling the gun trigger and turning the

adjustment knob on the Flowmeter

NOTE

Place MIG STANDARD/MIG PULSE

switch in the MIG STANDARD position

when using the Tig, Stick or Arc Gouging

process modes.

1 2 ... 11 12 13 14 15 16 17 18 19 20 21 ... 27 28

Keine Kommentare

ESAB MultiPower 460 Pulse Betriebsanleitung Seite 16