ESAB Powercut 650 Bedienerhandbuch PDF herunterladen (Seite 13)

3.6 ASSEMBLING PT31XLPC CONSUMABLE PARTS

The PT-31XLPC Torch is supplied complete; ready to cut and needs no further

assembly. If it becomes necessary to inspect the front end wear parts, see Figure

3.4 for correct assembly order.

Install the electrode, bae, nozzle, and heat shield as shown in Fig. 3.4. Tighten heat

shield snugly but do not overtighten.

Figure 3.4 Assembly of “XT” Consumable Parts

BE SURE to install the swirl bae in the

torch. Failure to do so would allow the

nozzle (tip) to contact the electrode.

This contact would permit high voltage

to be applied to the nozzle. Your contact

with the nozzle or workpiece could then

result in serious injury or death by

electric shock.

The PT-31XLPC torch head contains a gas

ow check valve that acts in conjunction

with the ow switch and circuitry within

the power source. This system prevents

the torch from being energized with high

voltage if the torch switch is accidentally

closed when the shield is removed. AL-

WAYS REPLACE TORCH WITH THE PROPER

TORCH MANUFACTURED BY ESAB SINCE

IT ALONE CONTAINS ESAB’S PATENTED

SAFETY INTERLOCK.

Make sure power switch on power source

is in OFF position and primary input power

is deenergized.

NOZZLE, SWIRL BAFFLE AND ELEC-

TRODE IN PLACE READY FOR INSTALLA-

TION OF HEAT SHIELD.

Electrode

20862

Swirl Bae

20463

Heat Shield

20282

Nozzle

20860

Torch Body

*20072

*Includes the following items:

Seat - 19679

O-ring - 950790

SECTION 3 INSTALLATION

1 2 ... 8 9 10 11 12 13 14 15 16 17 18 ... 55 56

Kommentare zu diesen Handbüchern

Keine Kommentare

ESAB Powercut 650 Bedienerhandbuch Seite 13

Kommentare zu diesen Handbüchern

Verwandte Produkte und Handbücher für Schweißsystem ESAB Powercut 650